————————————————
Accessories from
—
The Original
——
Rev. 00 22/10/2010
Page 2 of 3
Required handlebar type: LSL Fat Bar flat, Type XN1
Mount new handlebar into the clamps. Evenly tighten the handlebar clamps and tighten them
with 25Nm / 18.44lbf ft torque after the whole fitment is done.
Mount the handlebar controls and levers as shown and install the brake and clutch units
with approximately 25mm spacing to the controls, as shown.
Assure (without brake pressure) that the brake lever can be drawn up to the grip and
doesn’t contact the handlebar controls before.
(Loosening one calliper and wobble it on
the disk to push the pistons back should be the easiest way.)
Check clearance between fuel tank and handlebar as well as to the fairing; readjust handlebar
and controls if necessary.
K1200R:
To fit the left grip, drill two holes (3.5mm) and fix the grip with the original cutting
screws.
K1300R:
To fit the left grip, drill an end-to-end hole (4.0mm) and fix the grip with the original
bolt.
! !
