7
If you are owner of FuelGaugePro - Low Fuel Warning Light, follow next steps.
Setting up the FuelGaugePro - Low Fuel Warning Light function
Use only if you are connecting the Sensor together with FuelGaugePro - Low Fuel Warning Light kit.
It is needed to switch the output from continuous signal (factory settings) used for gauges to on/off
signal needed for Warning Light.
a)
Connect the Warning Light to the Display panel connector.
b)
Power the Sensor up.
c)
Hold the magnet included in package
with Warning Light near one of two
possible places of the Sensor as you see
on the picture. If Sensor recognizes the
magnet, the Warning Light start flashes
slowly.
d)
Hold the magnet for ca. 40-60 second
until the connected Warning Light start
flashing very fast (strobe).
(There are total 3 different flashing
speeds from slow to fast. You need to
wait for the fastest one.)
e)
Take the magnet out.
Set the threshold when the Warning Light is switched on/off.
a)
Fill the required fuel amount to the tank and make sure you have petcock opened well to all its
hydrostatic pressure can push on the Sensor.
b)
Proximity the included magnet as shows the picture. You should see the Warning Light start
flashes slowly.
c)
Hold the magnet on place few second until the Warning Light start flashes way faster. After that
immediately remove the magnet. Your threshold is now set up.
Obrázek vyměnit.
Reaguje to na opačném
konci senzoru!!
