LSILogik eXtreemeRAID 3000, Быстрое руководство по установке

Страница: 16 / 24

Installing the eXtremeRAID 3000 into the System Board
4 eXtremeRAID 3000 Quick Installation Guide
Installing the eXtremeRAID 3000 into the System
Board
1. With the power off, plug (install) the controller firmly into any 32 bit or
64 bit PCI slot, and wear a ground wrist strap as shown in Figure 4.
Notice that the black handle must fit into the side slot for a proper fit.
(refer to Figure 4).
Figure 4. Plugging the eXtremeRAID 3000 into a PCI Slot
2. Set the SCSI ID on each internal drive to a unique address between
0 and 15, but do not use address 7, as it is reserved for the controller.
See the documentation that comes with your drives for instructions on
how to do this.

Caution
Be sure to use a Fibre Channel Cabinet for the Fibre
disk drives. Do not mix SCSI and Fibre disk drives in
the same cabinet. There is no termination for Fibre
drives.
3. Disable termination on all SCSI drives connected to the controller. See
the documentation that comes with your drives for instructions on how
to do this.
Black handle
is the ISA
Extender