LSI Corporation
- 10 -
MegaRAID SAS 9285CV-8e RAID Controller Quick Installation Guide
March 2014
Attaching a CVFM03 Module to the RAID Controller and Connecting to a Remote CVPM02
Module
3.2.3
Installing the Clip on the Remote Mount Board
Follow these steps to install the clip directly on the remote mount board (sold separately).
1.
Place the remote mount board on a flat, clean, static-free surface.
2.
Ground yourself, and make sure that the system is grounded.
3.
Remove the clip and the remote mount board module from the package.
4.
Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
5.
Hold the clip so that the screw holes on the clip line up with the screw holes on the remote mount board, as
shown in the following figure.
Figure 6 Installing the Clip Directly on the Remote Mount Board
6.
Secure the clip to the CVPM02 module in three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
NOTE
Center the screwdriver carefully to avoid stripping the screw heads. Do
not over-tighten the screws.
A
A
A
Clip
3_00895b-00
