LSI Corporation
- 7 -
MegaRAID SAS 9267-8i RAID Controller Quick Installation Guide
July 2012
Installing the Controller
Figure 3 Installing the MegaRAID SAS 9267-8i RAID Controller
5.
Configure and Install the SAS Devices, SATA III Devices, or Both in the Host Computer Case
Refer to the documentation for the devices for any preinstallation configuration requirements.
6.
Connect the RAID Controller to the SAS Devices, SATA III Devices, or Both in the Host Computer Case
Use SAS cables to connect the RAID controller to SAS devices, SATA III devices, or both. See
connector locations.
7.
Turn on the Power to the Computer
Reinstall the computer cover, and reconnect the power cords. Turn on the power to the computer. Make sure that
the power is turned on to the SAS devices and the SATA III devices before or at the same time that the power to
the host computer is turned on. If the power is turned on to the computer before it is turned on to the devices, the
computer might not recognize the devices.
The firmware takes several seconds to initialize. During this time, the controller scans the ports.
8.
Run the WebBIOS Configuration Utility
Run the WebBIOS Configuration Utility to configure the groups and the virtual drives. When the message
Press
<Ctrl><H>
for
WebBIOS
appears on the screen, immediately press Ctrl+H to run the utility.
NOTE
Refer to the
MegaRAID 6Gb/s SAS RAID Controllers User Guide
on the
MegaRAID Universal Software Suite
CD for detailed information about the SAS cables.
NOTE
Refer to the
MegaRAID SAS Software User Guide
for detailed steps on configuring groups and
virtual drives.
3_00863-00
Edge of
Motherboard
PCI Express
Bracket
Skrew
Press
Here
Press
Here
