LSI LSI53C896, Техническое руководство

Страница: 175 / 370

SCSI Registers 4-63
Register: 0x22
Chip Test Five (CTEST5)
Read/Write
ADCK Clock Address Incrementor 7
Setting this bit increments the address pointer contained
in the
DMA Next Address (DNAD) register. The DNAD
register is incremented based on the DNAD contents and
the current
DMA Byte Counter (DBC) value. This bit
automatically clears itself after incrementing the DNAD
register.
BBCK Clock Byte Counter 6
Setting this bit decrements the byte count contained in
the 24-bit
DMA Byte Counter (DBC) register. It
decrements based on the DBC contents and the current
DMA Next Address (DNAD) value. This bit automatically
clears itself after decrementing the DBC register.
DFS DMA FIFO Size 5
This bit controls the size of the DMA FIFO. When clear,
the DMA FIFO appears as only 112 bytes deep. When
set, the DMA FIFO size increases to 944 bytes. Using an
112-byte FIFO allows software written for other
LSI53C8XX family chips to properly calculate the number
of bytes residing in the chip after a target disconnect. The
default value of this bit is zero.
MASR Master Control for Set or Reset Pulses 4
This bit controls the operation of bit 3. When this bit is
set, bit 3 asserts the corresponding signals. When this bit
is cleared, bit 3 deasserts the corresponding signals. Do
not change this bit and bit 3 in the same write cycle.
DDIR DMA Direction 3
Setting this bit either asserts or deasserts the internal
DMA Write (DMAWR) direction signal depending on the
current status of the MASR bit in this register. Asserting
the DMAWR signal indicates that data is transferred from
the SCSI bus to the host bus. Deasserting the DMAWR
signal transfers data from the host bus to the SCSI bus.
7 6 5 4 3 2 1 0
ADCK BBCK DFS MASR DDIR BL2 BO[9:8]
0 0 0 0 0 0 0 0
*