LSI ITI8000 Series, Руководство пользователя, Страница: 43 / 80

Configuring with Rear I/O Exits 2-15
Rev. 1.0 Copyright © 2000–2001 by LSI Logic Corporation. All rights reserved.
If the front ports are used alone, or the rear ports are used alone, then
the module terminates the SCSI bus. If the rear and front SCSI port on
either the A or B SCSI channel are used together, the module
automatically disables the onboard terminators for that port.
No manual configuration of the SCSI termination is required. The state
of the on-board termination can be monitored on the TERM LED on the
module handle.
2.5.2 Ethernet
To configure the ITI8241C-S Ethernet port to exit the rear of the system
cabinet through the ITI8241C-R rear I/O module, follow these steps:
Step 1. Locate J6, J7, J8, and J9. (See Figure 2.7 for jumper locations)
Step 2. Move the jumpers for each port to the Front “F” or Rear “R”
position.
Each port can be configured for front I/O ( Figure 2.7 ) or rear I/O
( Figure 2.8 ).
Figure 2.7 Ethernet Port Configured for Front I/O
R F
J9 = Port 3
R F
J8 = Port 2
R F
J7 = Port 1
R F
J6 = Port 0