UNITOUR Power System
User Manual
Page 16
2
Home Menu
The “Home Menu” shows the following information.
Home Menu
The various areas of the Home Menu are described below.
•
? (Help)
Tap
to see the software version and serial number. Help is also available on most other menus.
•
Rack ID
You can enter a descriptive name for the rack. See section 3.21.4.
•
Alarms
If an alarm occurs it will appear here on the screen. Tap for details. See section 2.1
•
LOG IN
Tap
to
access the “Quick” setup wizard (see section 3.3) and the “Advanced” Main Menu (see
section 3.11)
•
A red dot momentarily appears in the top right corner when settings are being saved
to the internal memory
•
Show Name
A show name appears here when the UNITOUR setup had been saved as a Show file or a
Show file has been loaded. See section 3.20
•
Input Voltages and Currents
The central section of the screen shows a real time display of the RMS voltage and currents
across all 3 input phases and the neutral. Voltages that are outside of the set limits are shown
in red (and the affected output channels will be automatically switched off). Currents that are
in excess of the set warnings are shown in yellow. To set these limits, see section 3.19.
•
Control Source and Patch information
If UNITOUR is being controlled by an external control signal (DMX, Art-Net, sACN etc), green
text appears showing information about the control source and the rack address as follows,
➢
If all channels are set to the same control source, it shows that source name. For
example, “DMX”.
Rack
Temperature
Touch
?
to
see Software
details
Status of input
Voltages and
Currents
Control
Signal status
Fan speed
Tap to
LOG IN
Rack ID: Name
Control Source
and Patch info
Menu buttons
Output Module
Status
Alarms
( if any)
Show name
(if show is saved
or loaded)
Red Dot =
settings are
being saved