Page 2 of 2 060-1000-0123-00
Using Pass Through Testing
1) Use the
MODE
button to select the testing mode to be used.
2) If
Pass Through Testing
setup has not been performed already, preset the
Pass Through
Testing
targets as described above.
3) Start the
Pass Through Test
.
a. If the
Pass Through
menu in not being displayed, press the
OPTION
button until the
screen shows “
Pass Through
”.
b. Press the
F2
button to
Start
Pass Through Testing
.
c. The menu display will close and the display will return back to the primary display.
4) The message “
Hit F1 to Start
” will flash on the screen.
5) Prepare the part for testing by placing it on the tester, then press the
ZERO FORCE
button to
remove the weight of the spring from the reading.
6) Press the
F1
button to start the test.
7) The
Pass Through Testing
data storage usage buffer will show as a percentage in the upper left
corner of the display. Before the display reaches 100% move the upper platform to pass through
the target position(s).
8) When the target has been passed or when the display hits 100% the result will be shown.
9) At this point result can be written down, stored, or sent out the printer port.
10) If the rate of change of the force was too fast, a message will be shown suggesting to slow down
the testing.
a. The rate of change is only checked near the target. It is possible to rapidly move the
platform to a point near the target. This is useful when passing through the second point
of a two point test.
11) Press the
ON/CLEAR
button to clear the measurement to prepare for the next test.
12) When finished using
Pass Through Testing
, the feature must be turned off.
a. Press the
OPTION
button until “
Pass Through
” shows, then press
F2
to
Stop
the
Pass
Through Testing
mode. Press the
ON/CLEAR
button to return to the primary display.
