Positioning and Installing the Booster
Note:
The best place to mount your Booster is on a ceiling or wall that is very high. The
idea is to get the signal as high as possible so it “umbrellas” the guest and thus all
pagers can receive it.
The booster operates at its best when installed at the “fringe” of your area. This means you
should get it as far from the transmitter as possible but still be able to receive the transmitter’s
signal.
1. Locate a 110V outlet near the selected installation location.
2. Plug the power adapter into the outlet and into the power connector hole on the
side of the unit.
3. Ensure that when power is plugged in, the Red RECEIVE light will blink continu-
ously to indicate power is on and the unit is operating.
4. Place the paging transmitter in “Range Test Mode” (see transmitter’s operating in-
structions).
5. Ensure the Red TRANSMIT light periodically alternate flashes on about every 5
seconds.
• If the periodic TRANSMIT flash does not occur, move the booster unit closer to
the transmitter and try again.
• Keep moving the booster toward the transmitter until the TRANSMIT flash oc-
curs.
• After establishing the correct distance, mount the booster as high as possible
Normal Range
Transmitter
TR-7400
Extended Range
SET
UP
MG
R1
MG
R2
STA
FF
CLE
AR
EN
TER
1
2
3
4
5
6
7
8
9
0
AB
C
DE
F
GH
I
JK
L
MN
O
PQ
R
ST
U
VW
XY
Z
[
T74
00A
Lon
g R
ang
e S
yst
em
s
800
.43
7.4
996
F1
F2
F3
F4
Transm
it
Power
9VAC
800.437
.4996
www.pa
ger.net
:
:
Long Range Systems
2
TR-7400 Quick Guide