LRS T7501, Руководство пользователя

Страница: 31 / 84

T7501 Page 5-5
6. Take 2 or 3 charged pagers and walk around the area. The pagers flash
about once every 3-4 seconds.
7. The point where the pager does not flash consistently is the maximum range.
To increase or decrease the range, see Prog TX Power. Repeat test until the
range is acceptable.
8. Press Enter to end the test.
T7501 Custom Setup
Access Code
NOTE : Access Code is needed for Setup functions.
To reduce tampering with critical settings functions that adjust paging and
operational preferences the T7501 is protected by access codes.

Access levels are Service (Highest), Admin, and Manager (lowest).

Each level allows privilege to the functions below but not above.

Access codes for Admin and Manager are usually set at the Service level.
To set access codes:
1. Press
Setup .
2. Select System , and then select Access Codes .
3. Select the level to change (service, admin, or manager) (Note: only the access
levels appropriate for the entered code will be displayed)
4. Enter the access code appropriate for the selected level.
5. Press
Enter.
6. Enter the new access code.
7. Press
Enter .
8. Press Exit to return to the main menu screen.
Setup Guest and Staff Pager Functions
NOTE : Access Code is needed for Setup functions (T7501 Custom Setup).
These functions effect the operation of the pagers.
1. Press
Setup
2. Select Pagers and press Enter.
3. Setup from Pager list
4. Select item from list and press Enter .
5. Make desired changes,
6. At end press
Exit
7. Select Yes to accept changes
8. Press
Enter .