USER MANUAL
|
RX-CS6, RX-CS7, & RX-AT9
LRSUS.COM | 3
GENERAL INFORMATION
The Guest Pagers are used in conjunction with the LRS transmitters. The guest pagers are
used as an on-premise paging system to increase efficiency by alerting customers who
are waiting, usually for services or goods.
SETUP AND USE
The low profile devices are rechargeable, water resistant, and can flash, and vibrate when
called by an LRS transmitter. To begin using your pagers, locate the charging base plate
near a power outlet and charge them for 16 hours.
Charger Installation
1. Install the charger base plate per the directions received with the charger kits.
2. Charge pagers for 16 hours prior to first use.
Note: Keep rechargeable pagers on charge even during extremely long periods of
inactivity.
WARNING:
Do not stack more than 15 guest pagers on a single charger base plate. Do not connect
more than 2 charger base plates to a single power supply. Only use the power supply that
came with your charger. Damage caused from improper electrical connection including
but not limited to the incorrect power supply is not covered under the standard warran-
ty. If you’re uncertain about which power supply to use, contact our customer support
department at 800.437.4996
Operation
1. When a guest arrives, remove a pager from the charging stack. Pagers will light up
and vibrate (if enabled) for 2 seconds.
2. Record the pager number and hand to your guest.
3. Page the pager by entering the number into the transmitter.
4. LRS Guest Pagers will flash or vibrate (if enabled) depending on the page mode sent
by the transmitter. Note: Beep is no longer supported. Beep modes will still flash
and vibrate (if enabled) with no audible beep.
5. Transmitters can also send predefined time limits for each of the pager alert modes.
See transmitter manual for details.
