L-DALI User Manual
181
LOYTEC
Version 5.2
LOYTEC electronics GmbH
2.
Right-click in the data point list and select
New Datapoint…
in the context menu. This
opens the register creation dialog as shown in Figure 166.
Figure 166: Create a user register.
3.
Enter a
Datapoint Name
for the register. You may leave the
Register Name
blank to
give the underlying register the same name as the data point.
4.
The standard setting is a value data point for read/write. Optionally, deselect the value
option and select the read data point or write data point check box. This is necessary
when configuring for an older firmware version.
5.
Select
Create as Parameter
if needed. In this case, the register will be a persistent
parameter. It can be done later in the data point properties also.
6.
Select a
Type
. Available are “Double”, “Boolean”, “Signed Integer”, “String”,
“Variant” or “User”.
7.
When selecting
User
, a register with a user-defined structure is going to be created.
Click on
next to
Custom Type
in order to select a structure type.
8.
In the dialog
Select Custom Type
choose the type
Category
in the drop-down list and
the desired user type. Then click the button
Select
.
9.
Click
Create Register
.
10.
If needed create additional registers from the dialog. Finally, click
Cancel
to exit the
dialog.
7.7.12 Build XIF for CEA-709 Interface
When using a non-standard static CEA-709 interface on the device, the Configurator can
export a new XIF file for the changed static interface. Before exporting the XIF for the
interface it is recommended to download the configuration into the device. In this case, the
Configurator can verify that the model number of the port is correct.
