Lowrance X102C, Руководство по эксплуатации

Страница: 19 / 92

15
Position transducer mount on transom and mark mounting holes.
Side view shown, left, and seen from above at right.
5. Attaching transducer to transom.
A. One-piece bracket: Remove the transducer from the bracket and
re-assemble it with the cable passing through the bracket over the
bolt as shown in the following figures.
For single-frequency Skimmer, route cable over bolt and through
bracket. Side view shown, left, and seen from above at right.
Both bracket types: Attach the transducer to the transom. Slide the
transducer up or down until it's aligned properly with the bottom of
the hull as shown in the preceding and following figures. Tighten the
bracket's mounting screws, sealing them with the sealant.
Adjust the transducer so that it's parallel to the ground and tighten
the nut until it touches the outer washer, then add 1/4 turn.
Don't
over tighten the lock nut! If you do, the transducer won't "kick-up" if
it strikes an object in the water.
Transom
Transom