R 1 7 3 5 R E M O T E C O N T R O L
Notice:
Do not expose the unit to moisture or heat. When
you use the control unit, if emission distance is short
and less effective, please replace battery. Please
recycle batteries.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Technical specification
Input voltage: 3V (CR2450) X 1
Transmitting frequency: 433MHz
Transmitting power: 10 milliwatt
Operating temperature: -10
0
c to 50
0
c
Transmission distance: 200 metres open office, 35 metres on two walls
• Press the down button and the blind will start to go down
• Press O and + together and the blind will go into slow jog mode
• Press the stop button on the remote and the blind will stop
• Press and hold the stop button down until the motor jogs twice and beeps, this will set the lower limit
Setting is complete. For more blinds, select another channel on the remote and repeat step 2.
STEP 3 - SETTING A THIRD POSITION
• Move the blind using the up and down buttons the remote to the desired position press stop
• Then O and + together followed by the stop button twice more, this will cause the motor to jog twice and beep
• To operate the third position, press and hold the stop button and the blind will move to its third position
• To delete the third position, press O and + together, followed by the stop button twice, the motor will jog twice
DELETING A LIMIT
• To delete a limit, press O and + together followed by the down button then press O and + together again, the motor will jog twice
DELETING A HANDSET
• To delete a handset, press O and + together then the stop button followed by O and + together again, the motor will jog twice and beep
ADDING A HANDSET
• To add a handset, press O and + together twice on the existing handset. Then press O and + together on the new handset, the motor will
jog twice
• R1725 - To perform a factory reset press and hold the button on the motor for 6 jogs
• R1740 - To perform a factory reset press and hold the button on the motor for 1 jog then turn off the power for 20 seconds
Oct 2017
