R 1 7 3 0 R E M O T E C O N T R O L
• Press P2 and the blind will go into slow jog mode
• Press the stop button on the remote and the blind will stop
Press and hold the stop button down until the motor jogs twice, this will set the lower limit.
Setting is complete. For more blinds, select another channel on the remote and repeat from Step 2.
STEP 3 - SETTING A THIRD POSITION
• Press P2 followed by the stop button twice more, this will cause the motor to jog twice
• Move the blind using the up and down buttons on the remote to the desired position (press stop)
• To operate the third position, press and hold the stop button and the blind will move to its third position
• To delete the third position, press P2, followed by the stop button twice, the motor will jog twice
DELETING A LIMIT
• To delete a limit, press P2 followed by the down button then press P2 again, the motor will jog twice
DELETING A HANDSET
• To delete a handset, press P2 then the stop button followed by P2 again, the motor will jog twice
ADDING A HANDSET
• To add a handset, press P2 twice on the existing handset. Then press P2 on the new handset, the motor will jog twice
• R1725 - To perform a factory reset press and hold the button on the motor for 6 jogs
• R1740 - To perform a factory reset press and hold the button on the motor for 1 jog then turn off the power for 20 seconds
Notice:
Do not expose the unit to moisture or heat. When
you use the control unit, if emission distance is short
and less effective, please replace battery. Please
recycle batteries.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Technical specification
Input voltage: 3V (CR2450) X 1
Transmitting frequency: 433MHz
Transmitting power: 10 milliwatt
Operating temperature: -10
0
c to 50
0
c
Transmission distance: 200 metres open office, 35 metres on two walls
Oct 2017
