Technical data
Battery specification: Li-ion battery, 2000mAH, 7.4V.
Motor Torque/Speed: 1.1Nm/25rpm
Set-up lower limit
1. Press and hold the
LIMIT
button
on the remote until the motor jogs
4 times and then release the button.
2. Press
DOWN
button on the
remote to move the blind down
and press
STOP
when desired
lower limit is reached.
3. To set the lower limit more accurately
press
DOWN
and the motor will run
down in steps.
4. Press
CONFIRM
button on the
remote and the motor will jog 2
times, the lower limit is set.
A.
Remove grease protector ring by
opening the split ring and sliding off
the motor body
B.
Fit crown by opening the split ring
and slide along the motor body until
it meets the motor head.
C.
Fit the drive using the cir-clip to
secure in position.
D.
Attached motor plate with the screws
supplied in either left hand or right
hand orientation as required.
Attaching the solar panel
• Make sure the motor has enough
charge to operate the blind.
• Attach the solar panel to the charge
port on the motor using the 1.5m
charge cable.
• Place/ fix the solar panel so that it is
facing direct sunlight.
Change motor direction
1. Press
UP
button on the remote, if the
blind goes up then the motor
direction is okay.
2. To change the motor direction
hold down the
LIMIT
button and
then press
STOP
button on the
remote transmitter, the motor will
jog to indicate the direction has
been changed.
Pairing an additional remote with the
motor
1. Hold down the
SETTING
button
on the motor until it jogs 2 times
and then release the button.
2. Press the
CONFIRM
button within
10 seconds. The motor will jog 2
times and the remote is now
paired with the motor.
Pairing the remote with the motor
1. Select the channel for the blind using
the
C/-
button.
2. Hold down the
SETTING
button on
the motor until it jogs 2 times and then
release the button.
3. Press the
CONFIRM
button within 10
seconds. The motor will jog 2 times
and the remote is now paired with the
motor.
Set-up and operation
Setting up the motor
• The side of the motor mount with the
SETTING
button should face you.
• The motor antenna should be as straight as possible; otherwise the receiving
distance will be reduced.
•
Charging -
The motor works with Li-ion battery, please charge when the motor
stops working or falters please charge the motor by charger. Charging time with
the charger is 5 to 6 hours. Please do not leave the motor on permanent charge
as this will reduce battery performance.
NOTE: On receiving the motor we recommend fully charging.
Setting button (Red)
Remote Transmitter
Charge port
Antenna
Motor assembly
Setting button (Red)
Setting button (Red)
Primary
Secondary
1
1
1
2
2
3
4
1
2
2
