INTERCONNECTION DIAGRAM
CONNECTING LOUROE MODEL AOP-SP-E
DIRECTLY TO AN IP CAMERA, DVR,
VIDEO SERVER, ETC. USING 3-COND. SHIELDED CABLE
EXT
MIC
SPKR
+12Vdc
AUDIO
OUT
AUDIO
IN
TALKBACK
ADJUST
MIC
ADJUST
C
A
SP
B
LOUROE MODEL AOP-SP-E
WHITE (SP)
BLACK (C)
(C) BARE
(B) RED
TO AUDIO OUT OF IP CAMERA, DVR, ETC.
TO AUDIO IN OF IP CAMERA, DVR, ETC.
NOTE: BLACK AND BARE WIRES ARE COMMON GROUND
BARE (C)
BLACK (C)
RED (B)
4-PIN TERMINAL BLOCK IDENTIFIER OF AOP-SP-E (A,B,C,SP)
(
) B = Audio Output
(
) C = Ground (audio) and Ground (speaker) (black wire)
(
) SP = Speaker output
A = not used with this application
red
bare
white
West Penn 358
or equivalent
C
A
SP
B
WHITE (SP)
Audio Out
Audio Out
Audio In
Audio In
Bare Wire
Red Wire
RCA CONNECTION
3.5mm MONO CONNECTION
3.5mm STEREO CONNECTION
White Wire
Black Wire
Black Wire
White Wire
Red Wire
Bare Wire
M
O
N
O
S
T
E
R
E
O
Audio Out
Audio In
Red Wire
Black Wire
White Wire
Bare Wire
WIRING REQUIREMENTS
3 Conductor consisting of:
+
2 Conductor
shielded
, 20 gauge
with 22 gauge drain
+
1 Conductor
unshielded
, 20 gauge
All in the same jacket
+12Vdc,500mA power required
(AD-1 power supply included)
Connect to this 2-pin terminal block
ELECTRET
CONDENSER
MICROPHONE
AUDIO
OUT
AUDIO
IN
AOP-XD is not used for this application.
Page 4 of 8
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX
994-6458
Website: www.louroe.com Email: [email protected]
(818)
AOP-SP-E 8/09
12 Vdc power is required to connect the AOP-SP-E directly to
an IP camera or DVR such as AD-1 power supply.
Positive 12Vdc connects to terminal marked “
+
”
Negative 12 Vdc or ground (with white stripes)
connects to terminal marked “
GND
”
INSTALLATION AND OPERATING INSTRUCTIONS
+12Vdc
+
GND
