T80 Quadcopter
Lotus
RC
2.
Battery installation
•
T80 model main power battery is fastened securely under the
main body, easy to dismantle. Battery with standard configuration is
2S 850mAh 15C Li-poly
battery, the recommended maximum battery
size is
2S 1300mAh
. Flight time will be extended accordingly, but
battery capacity’s increase may not be directly proportion with flight
time, as larger battery’s increased taking off weight, this will lower
model’s thrust-weight ratio and reduce flight maneuver performance .
3.
Remote controller installation
Set remote controller with NO mix control fixed wing mode, rudder
travel at 100%. Trim adjustment turn to middle level. If it is new
remote controller equipment, please confirm it is in working
condition.
Power on RC, and set throttle stick to the lowest level, then put
model on the stable flat ground; you may use the level meter to
ensure the model on a good level condition, it’s
vital
to hovering.
Power on the model, then a warning tone will come out from four
brushless motors; when the warning tone end, it means it can fly.
Attention
: do not move the model while it is on initial powered up,
model needs to do self-checking on transducer, only move the model
after self-checking is finished.
4.
Operational check
T80 quad-copter is designed as a only as standard ”+” flight mode. Put
model in front of you with the yellow arm pointing front. Check to
ensure your radio stick movement control the model at the right
direct.
Picth stick forward will tilt the model forward and roll stick right the
model will roll right. When rudder left, the model will yaw left,
pointing the head to left.
