Lotus H370 Petite, Инструкции по сборке и использованию

Страница: 4 / 15

Pic.2
A: Holes used for fastening the insert to the base.
B: Set screws for adjustment of the insert in relation to the base.
C: Set screws for adjustment of the combustion champer in relation to the cabinet.
Pic.2
A: upper smoke turnplate-B: lower smoke turnplate-C: Skamol must be removed
to gain access to the adjusting/fastening screws.
The potential for the building-in of fireplace inserts is vast; they may be built into the
wall, on the outside of the wall, and may be suspended on the wall. Building-in shall
take place in connection with non-inflammable materials only. Virtually all
installations are designed individually, and in all cases the distance to inflammable
matter must meet the values stated below.
By setup in connection with inflammable material, you must create a structure to the
cassette by a steel frame and super isol plates (or plates of equal or better insulation),
see example with minimum measurements.
The Base
The base must, of course, be firm and have adequate load-bearing capacity. This will
usually pose no problem when assembling in an open fireplace.
In case of an inflammable floor, the height of the foundation for the insert must be
minimum 300mm.