INSTALLATION OF RECEIVER
CONNECTING A RECEIVER TO A REMOTE TV THROUGH A VCR
Rear of
VCR
Audio Video
RCA Cable (Supplied)
RCA Cable
(Not supplied)
Television
Electrical Outlet
Ensure the Power Switch on the Receiver is turned OFF before
proceeding with the following steps.
NOTE
1. Connect one end of the RCA cables to the Audio/Video output jacks located
at the rear of the Receiver. Plug the other end of the RCA cables into the
Audio/Video In jacks on your VCR.
2. Connect one end of other RCA cables to the Audio/Video jacks on your
Television. Plug the other end of the RCA cables into the Audio/Video Out
jacks on your VCR.
3. Turn both the Transmitter and Receiver ‘ON’. Set your TV to Video mode
to view the signal from the T.V. (Consult your televisions owners manual on
setting the Television to Video (Aux) mode.
4. Turn your T.V. to AX (Aux. Mode) to view the picture on your second T.V.
5. Adjust the antenna direction on both the transmitter and receiver as
necessary for optimum viewing.
For optimum viewing reception you may need to change the
channels of your transmitter and receiver to the same channels
between CH 1 – CH 4.
NOTE
8
Back of Receiver
