Lorenz DR-1986, Руководство по эксплуатации

Страница: 12 / 12

LORENZ MESSTECHNIK GmbH Obere Schloßstr.131
73553 Alfdorf  07172 / 93730-0
Fax 07172 /93730-22
E-Mail: info@lorenz-sensors.com Technical changes reserved 090327.docx
Internet: www.lorenz-sensors.com Page 12 of 12
10 Disposal
The torque sensors must be disposed according to the valid provisions of law.
For this, see our “General Terms and Conditions”
www.lorenz-sensors.com
11 Calibration
At the time of delivery, torque sensors have been adjusted and tested with traceable calibrated measuring
equipment at factory side. Optionally, a calibration of the sensors can be carried out.
11.1 Proprietary Calibration
Acquisition of measurement points and issuance of a calibration protocol. Traceable calibrated measuring
equipment is being used for the calibration. The sensor data are being checked during this calibration.
11.2 DKD-Calibration
The calibration of the sensor is carried out according to the guidelines of the DKD. The surveillance of the
calibrating-laboratory takes place by the DKD. At this calibration, the uncertainty of measurement of the
torque measuring instrument is determined. Further information can be obtained from Lorenz
Messtechnik GmbH.
11.3 Re-Calibration
The recalibration of the torque sensor should be carried out after 26 months at the latest.
Shorter intervals are appropriate:

Overload of the sensor

After repair

After inappropriate handling

Demand of high-quality standards

Special traceability requirements
12 Data Sheet
See www.lorenz-sensors.com
13 Literature
Dubbel, Taschenbuch für den Maschinenbau, Springer Verlag