LORAD AFFINITY Series, Руководство по обслуживанию

Страница: 37 / 214

P/N 9-500-0255 2-7
Service Manual
Chapter 2: System Installation
Unit Installation
3.4.2 Control Panel Remote Location Installation
For units that are configured for remote operations, the Remote Control Panel Kit (3-
000-5042) is included (refer to Figure 2-5).
The kit consists of the
following:
•
Housing and Hous-
ing Mount
• Control Panel and
EMO Switch Harness
(2 50 ft cables)
• EMO Switch - Emer-
gency Stop Switch
Figure 2-5: Remote Control Panel Installation
Install the Remote Control Panel as follows:
1. Mount the Control Panel housing bracket (Figure 2-5, Item 1) to the wall (or
other mounting apparatus) in the remote location using the supplied hardware.
2. Route the Control Panel and EMO Switch harness through the strain relief
(Figure 2-5, Item 4), then out the access hole in the housing bracket. Make all
the appropriate harness connections, then tighten the strain relief.
3. Mount the Control Panel housing (Figure 2-5, Item 2) to the housing bracket
using the supplied hardware. Note that an EMO switch is mounted on the
housing.
4. Align the tabs on the rear of the Control Panel (Figure 2-5, Item 3) with the slots
on the housing. Insert the tabs into the slots and slide the Control Panel down to
lock in place.
5. Connect the end of the Control Panel interconnect cable to the Remote Control
receptacle (Figure 2-6, Item 8) on the rear connector panel.
6. Connect the Emergency Stop Switch interconnect cable to the Emergency Stop
receptacle (Figure 2-6, Item 9) on the rear connector panel.