Maintenance
3 5
© Travis Industries
4080728
1 0 0 - 0 1 1 5 6
Yearly Maintenance (or every ton) - continued
Clean the Exhaust Blower
Restrictor Knob
a
Open the hopper lid
and remove the
screw holding the
left door in place.
Remove the
restrictor knob.
Swing the left side
panel open.
Remove the six screws holding the
exhaust blower motor in place.
b
11/32" Socket
c
Pull the motor out (be careful not to damage the wiring or
blades - replace gaskt if it is damaged).
Phillips
Screwdriver
d
Exhaust
Motor
Blower
Blades
Blower
Housing
Exhaust Box
Clean the blower blades, blower housing, and exhaust box. You may wish to
use a vacuum to pull ash out of the vent system. When replacing the motor,
take care to align the gasket (if it is damaged, replace). Check the nipple and
flow switch tube. Insert a pipe cleaner through the nipple to dislodge any
flyash. NOTE: The flow switch will shut off the auger if the tube becomes
Flow Switch
Tube
Nipple (attached to
exhaust box)
Clean the Vent
Check the vent sections for creosote
accumulation (indicating a poorly burning
stove). Accumulation over 1/4” must be
removed.
On vertically vented systems, the dirtiest portion
is often the point where the vent turns upwards
(i.e. the "Tee"). Fortunately, the "Tee" has a built-
in clean-out cover. Place a container under the
“Tee”, disconnect the cover and remove all flyash.
While open, use a flashlight to look up the vent to
check for build-up.
Make sure the cap is free of debris
(especially if it has a screen that could
become blocked).
Flyash will deposit along
sections that are horizontal.
AA
AA
AA
AA
Warning:
Whenever any portion of the pellet vent is disconnected, the joints must be sealed with
RTV 500
°
F. silicone sealant.