Small Pedestal (1250 / Answer)
99200122
Page 3 of 4
9/4/08
© Travis Industries, Inc.
Outside Air Installation – Through the Pedestal into the Crawl Space
This pedestal has an internal air duct that may be used to direct air to the firebox. Outside air is then drawn from
the crawl space under the stove (check with local building codes for requirements in your area). See the
directions below for installation details.
1
Determine the location of the hole placed under the pedestal. The illustration below details the location of the
pedestal in relation to the front of the stove. The hole should be at least 16 square inches.
15
12"
23 1/2"
16"
Outside air may be drawn
from this area underneath
the pedestal
(min. 16 square inches)
Top View
The faceplate of the Answer
is flush with the front of the
forward edge of the pedestal
base.
The faceplate of the 1250 is
1/4" in front of the forward
edge of the pedestal base.
FRONT
2
Outside Air Cover Plate (Required on the Answer ONLY) When using outside air with the Answer, install
the cover plate to insure combustion air is drawn from below.
Remove the air control stop on the stove.
Remove the bridge and plugs from the front of
the cover plate.
Re-attach the bridge to complete the cover plate installation.
Attach the air control stop and cover plate as
shown above. HINT: Place one screw through the
cover plate and air control stop, and while holding
them together, slide the components into place
and tighten the screws to secure.
