05
04
USB Port - Backup
Router
Security System Connection
To ensure that the product works properly and not damaged while in transit,
we recommend you to test the whole system before installation.
(1)
Install the antenna on the back panel of the NVR as shown in the diagram <NVR
Back Panel> on page 1.
(2)
Next install the other antennas on the back of each cameras. Make sure the
antennas are tighten.
Note:
Antennas for NVR and Cameras are the same.
(3) Connect the monitor to the NVR using HDMI or VGA.
(4) Use a network cable to connect the NVR to the router.
(5) Insert the USB mouse into the USB port on the rear panel of the NVR
(6) Connect the cameras to the power adapter (DC 12V/1A).
(7) Connect the power adapter (DC 12V/2A) to the NVR power input.
(8) Plug power adapters into the wall socket.
(3) Click on the search button on the IPC channel configuration page to search for the
corresponding IPC;
(4) If you want to add the camera, select the IPC you wanted to add from the search result
and click wireless add. Upon successful connection, the connected IPC will appear at the
bottom of the page. Now you can see live feed from the newly added channel of the camera.
If you want to reset the camera, select the IPC to be reset from the search list, then click
"Reset IPC", and wait for the camera to reset successfully. Repeat the above steps to
reconnect the camera.
The cameras have been paired before shipping. Simply plug and play. It is recommended
to test the system with the cameras before installation. If it does not work, try resetting the
camera. If the problem still persists, please contact Loocam customer service.
To add a new camera or reset the camera, please follow the following steps. Take out the
camera and install the antenna. Next connect NVR and camera with a network cable. Make
sure the system can display normally on the monitor before performing the steps below.
(1) Right-click on the mouse which is connected to the NVR for operation menu.
(2) Click on the <IPC channel config>to enter the IPC channel configuration interface.
Paring Add-on Camera
