127
2. Screw on the oil outlet screw piston, and then fill in the clean engine oil from the inlet
port to the oil level of "H" of the clean-foot scale. Run the engine under the idle speed
to inspect whether there are any leakage occurred on the oil filter and oil outlet piston.
3. Turn Engine off, about 10 minutes later, allow the engine oil fully to flow back into the
oil pan, and re-check the oil level, if the oil is in shortage, please refill the oil until the
oil falls between “L" and "H" level of the foot scale.
Change the oil filter when change the engine oil.
5.8.7 REPLACEMENT OF ENGINE OIL FILTER
1. Clean the area near to the install seat of the filter of the engine.
2. Remove the oil filter with the belt wrench.
3. Clean the contact surface of the seal gasket of the install seat with a clean cloth. If
the old O-ring is glued to the install seat, replace it.
4. Install a new O-ring, fill the new oil filter full with clean oil, and seals the contact
surface with a layer of clean engine oil.
5. Install the oil filter to the install seat; tighten it to the surface of the oil filter gasket with
install seat. Tighten the oil filter according to the regulated requirement with belt
wrench.
6. Inspect oil level; if the oil is insufficient please add more.
To tighten the oil filter excessive tight may damage the seals and cause leakage.
5.9 INSPECT ELECTRICAL SYSTEM
The electrical system of the machine is mainly consists of batteries, energy conversion
devices (generator, starter) and power consuming devices (instruments, devices, etc.).
Warning
Warning
