2
INSTALLATION
GENERAL INSTALLATION NOTES
IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY
BEFORE PROCEEDING. STRUCTURE MEASUREMENTS
MUST BE VERIFIED AGAINST THE UNIT. ENSURE THE
STRUCTURE MEETS THE REQUIRED DIMENSIONS, IT IS
LEVEL AND SQUARE.
Check that floor is level, adjust as necessary. Shimming may be
required to level the bathware unit to ensure adequate drainage.
Levelling must be done under the wood base beneath the unit.
Do not level directly behind or under the flange and/ or at the
front of the unit.
ALWAYS ENSURE THAT THE SURFACE OF THE UNIT IS
PROTECTED TO PREVENT SCRATCHES IN THE SURFACE.
INSTALLATION STEPS
1. Unpack the bathtub and be very careful during installation
so as to not damage the acrylic surface of the tub.
2. Position the tub in the area where it will be installed. Mark
the centre of the drainage line in relation with the desired
position of the bathtub.
(
Figure 1
)
3. Carefully remove the tub interior from the apron of the tub
by lifting the tub interior from its fastening/alignment pins.
(
Figure 2
)
4. Align the centre of the drainage line with the sub-floor
Cutout Template. Cut a 6-1/2" (16.5 cm) hole into wood
sub-floor (use supplied Cutout Template).
5. Measure and cut ABS Tailpiece as necessary to ensure a
secure connection to P-Trap below.
6. Insert Drain assembly into floor opening and connect to
pipe below.
7. Affix to sub-floor with 6 screws (not supplied)
8. Install flooring surface, leaving a 6-1/2" opening to access
Drain.
Every effort has been made to offer the most current, correct, and clearly expressed information possible. Nevertheless, inadvertent errors or inaccuracies in the information may occur.
Longevity Acrylics disclaims any responsibility for errors or accuracy of information that may be contained in its documents or web pages. Longevity Acrylics Inc. makes no warranties or
representations whatsoever regarding the quality, content, completeness, suitability, adequacy, sequence, accuracy or timeliness of such information and data.
centre of
drain location
FIGURE 1
mounting brackets
alignment pins
FIGURE 2
