LOMO GLADIOLUS, Руководство пользователя

Страница: 10 / 39

When you turn the switch B3 ON, power supplied to the remote control and indicator lamp L2 ‘POWER’ lights up.
When you press the button B1 ‘START’, lamp L1 ‘WORK’ lights up, and 27V DC supplied to the control unit (for
commutating of the camera power) through the button B2 ‘STOP’ and pin 3 of the connector III1. 27V DC supplied to the pin
14 of the connector III1, locks the button B1 ‘START’ through the control unit. Selector B5 is used for setting required
shooting speed.
If camera runs correctly, indicator lamp L3 ‘BREAK’ is off. If there is no film in the camera, or film is broken, the lamp L3
‘BREAK’ lights up in 1-2 seconds after pressing the button B1 ‘START’.
Button B2 ‘STOP’ stops the camera.
Upon appearing an impulse corresponding to every 50
th
frame on the pin 6 of the connector III1, electro-mechanical counter
IP1 advances length of exposed film in meters with 4.5% accuracy.
After mounting other mag onto the camera, it is necessary to reset the counter by means of the button situated on the counter.
If you operate the camera from the remote control unit, set the speed selector into ‘REMOTE’ position.
If power supplied incorrectly, the button B1 ‘START’ will not run the camera, and lamp L2 ‘POWER’ will be off.
Figure 6. Electric circuit of the remote control unit