LOKERMANN GRAND MIG 160, Руководство пользователя

Страница: 8 / 14

4
Operation
4.1
Layout for
the front and
rear panel
1. Output “-“
2. MIG GUN Connect.
3. Welding current/wire speed knob: Set the welding current/wire speed.
4. Welding volt knob: Set the welding volt
5. Alarm Led: When the welder is over voltage, less voltage, over current or over heated, the alarm
pilot lamp will be on.
6. Voltage display: Welding voltage display when machine is working, Set voltage display when MIG
mode before welding. Unit
： V.
7. Power Led: Power led is lighted when switch on the machine.
8. Current display: Welding Current display when machine is working, Set current display before
welding. Unit
： A.
9. Wire speed LED: You can use current setting knob to set the wire speed when the wire speed
LED is on.
10. Choose welding mode button: Pressing the button can choose 2T or 4T welding mode.
11. 2T welding mode LED: When the 2T welding mode LED is on , it can 2T welding mode,2T is suitable
for the short welding.
12. 4T welding mode LED: When the 4T welding mode LED is on , it can 4T welding mode, 4T is suitable
for the long welding.
13. Wave control knob: Controls arc characteristics, Determines the rate at which the amperage
rises when a short circuit is produced, decreasing the spatters.
14. Current LED: When the current LED is on, it display the actual output welding current.
15. Power source input: To connect power source.
16. On/off switch: Control the power supply on and off.
17. Shield gas input joint: To connect one head of the gas hose while the other head of which is
connected to the gas cylinder.
18. Inside the wire feeder compartment there is the BBT knob (burn back time).
19. Inside the wire feeder compartment the is the possibility to inverse the polarity in order to weld flux
wires that required it.