Operating instructions
ScanAfia X TK, S, ICU Version 1.5
Copyright © Lojer Oy, 2015
27
IMPORTANT!
Do not run the bed movements daily with battery power.
Battery use is intended for emergency situations only when no
mains power is available. The bed must be plugged in
whenever possible. When the bed is plugged in, the battery
charge level is under control and the battery charges
automatically.
IMPORTANT!
To use the battery system of a bed equipped with one, the
battery must be charged for at least 14 hours after storage or
before it is first commissioned. After charging the batteries,
make sure the battery system is in working order before using
it.
6.11
Removing and fastening the bed surface's plastic
boards
The plastic boards can be removed from the bed to facilitate cleaning. The
plastic boards are fastened to the metal structure with adhesives. The 2 function
and 4 function beds and the beds with a width of 80cm and 90cm have different
plastic boards (Figure 58).
Before removing the plastic boards, adjust the bed's backrest, thigh and leg
rests in the horizontal position. Remove the bed surface's plastic boards by
lifting the board on the side of the bed.
IMPORTANT!
When attaching the plastic boards to the bed, make sure that
the boards you fasten are of the correct shape and width.
IMPORTANT!
Make sure that the plastic boards are reattached correctly to
the bed.
IMPORTANT!
Make sure that you attach the plastic boards according to
Figure 58 below.
Figure 58.
Plastic boards of 2 and 4 function beds
Head end
Foot end
