Operating instructions
ScanAfia X TK, S, ICU Version 1.5
Copyright © Lojer Oy, 2015
20
6.3 Moving and transporting the bed
IMPORTANT!
Move the bed by the foot of the bed where the brake pedals
and brake arc are located. The normal way to transport a
patient in the bed is head first.
IMPORTANT
Always unplug the power cable before moving the bed. Make
sure that the cable is not crushed between the bed's
structures or wheels.
IMPORTANT!
Always disconnect the equipotential cable before moving the
bed.
IMPORTANT!
We recommend that you disconnect all protruding accessories
of the bed to minimize the risk of collision.
IMPORTANT!
To transport the patient, lower the bed surface to its lowest
position and raise the rails to minimize the risk of falling.
6.4 Adjusting bed surface height
The height adjustment function of the bed surface is driven by an electric motor.
The height of the bed surface can be adjusted within the range of 30-82 cm
depending on the bed model and wheel size.
IMPORTANT!
Adjust the bed surface to be horizontal before adjusting bed
height. (Note! S model beds with gas spring driven
Trendelenburg / reverse Trendelenburg adjustment).
IMPORTANT!
Before adjusting the bed or rails, make sure that nothing and
nobody is under them or between their mechanisms. (danger
of crushing). Be careful when the rails are in the lower position
and when lowering the bed surface (danger of crushing).
IMPORTANT!
The hospital bed must always be left in its lowest position to
minimize the risk of falling and to ensure safe operation.
IMPORTANT!
Depending on the model, the bed may make a beeping sound
when the bed surface lowering button is pushed to indicate
that the bed is already in its lowest position.
