6
Copyright © Lojer Oy, 2013
02/2013 Rev. 1.0
2.2
Before use
The device
is intended to be used in normal, dry indoor conditions. Ensure that the temperature of the room is b10…40
°C and the humidity is within the range of 30…75 %. If there is chance that device has been exposed to temperatures below 0°C
,
allow it to adjust to the indoor temperature for at least 5 hours before using any of its features.
Familiarise yourself with the instructions and carry out the following before using the table:
Make sure that all packing materials have been removed
Make sure that the device can move freely uo and down.
Place the device in the location where it will be used and lock the castors.
Connect the power plug to a socket whose supply voltage corresponds to the voltage shown on the device’s
type plate. Make sure that the cord runs freely from the connection box.
For safety reasons always connect the power cord to grounded socket.
Do not bind the power cord to the device as the lifting motion can severe the cord. Ensure that the cord is easily
detachable in an emergency situation.
Make sure that the distance to the socket is not more than 2 meters.
Always detach
the power cord before moving the device. Make sure that the cord doesn’t get stuck between
parts of the frame or under the castors.
If the power cord is damaged, unplug it immediately. Do not use the device and contact the service. Use only the
original power cord.
Make sure that the patient doesn’t accidentally move/touch the place free bar or any other control device.
Do not place anything under the device (e.g. chair, because the device has to be able move freely). Make sure
that the patient’s limbs do
not get caught in the frame of the device.
Do not place the device under any wall structures or too close to the wall.
Do not modify the structure of the device or install parts other than those mentioned in this document.
Do not use the device or the acce
ssory if it doesn’t work properly.
Contact the service
Do not lift the device from the head section, arm rests or the side supports. Do not push the device on to a door
sill.
WARNING!
Children or people with no experience of the device or those with restricted understanding must not
use the device. Children must be supervised to ensure that they do not play with the device! For safety reasons
use the safety switch or unplug the power cord when the device is left unsupervised.
3
Using the treatment table
Note!
Do not use the electrical functions of the device non-stop for longer than the permissible two (2) minutes. Longer continuous use may
cause the transformer to overheat. If you use electrical functions non-stop for two (2) minutes, keep to the operating time ratio and do not use
any electrical functions for 18 minutes.
3.1
Maximum inclination
The height adjustment range of the Delta treatment tables:
Standard; 1MD4 57-87 cm, 1MD7L and 2MD602 58-89 cm
Professional; 1MD4 47-98 cm, 1MD7L and 2MD602 48-100 cm.
The foot section adjustment range to 75 ° angle.
