Logosol SH410, Руководство пользователя

Страница: 15 / 32

15
LOGOSOL SH410
MOULDING KNIVES
Guide the wedge
with moulding
knife into the
widening in the
cutter's side.
WARNING! Cutter imbalance creates vibra-
tions which can damage the machine and
cause personal injury.
Moulding knives must always be fitted in pairs,
so that the cutter remains well balanced.
ASSEMBLY:
• Assemble wedge (D) and moulding knife (E).
• Guide the wedge and moulding knife down the
side of the cutter where the wedge groove is
expanded.
• Push the knife and wedge into the track and at-
tach through screwing out the screw on the rear
of the wedge.
The locking screw is not to be above the
groove of the wedge track.
• Measure the knife's lateral position and fit an
identical knife exactly on the cutter's opposite
side.
REPLACING CIRCULAR SAWBLADE
DISMANTLING:
Remove the protective cover for the belt transmis-
sion and the rear protective cover for the chain
transmission.
Loosen the belt tensioner and bend the belt off the
spindle pulleys.
Remove the saw spindle through loosening the two
stop screws on each ball bearing inner ring. The
spindle can now be pushed out towards the pulley.
Push out the spindle one decimetre. The four screws
on the blade centre can now be loosened and the
blade can be replaced.
ASSEMBLY:
Clean the bearing and spindle carefully. Fit
the circular sawblade onto the spindle.
Only circular sawblades supplied by Logosol are to
be used.
Fit the protective covers.