logitrans ELFRRE, Руководство пользователя

Страница: 23 / 32

23
A1
A1
A2
A2
B1
B2
ca.5mm
ca.2-3 mm
6.8 Adjusting the Reel Rotator
Tensioning the chains (ELFRRE&ELFSRRE)
When the unloaded reel carriage can be tilted manually approx. 2 cm, measured at
the rear carriage, the chains should be tensioned.
This is done by:
1. Removing the cover from the reel carriage.
2. Loosening the gear motor (A1)
3. Loosening chain wheel (B1)
4. Turning the nut (B2), so that the large chain is tensioned, until the slack is
about 5 mm.
5. Tightening the chain wheel (B1)
6. Tightening the nuts for the gear motor (A2), so that the chain is tensioned,
until the slack is about 2-3 mm. Tighten the nuts (A1) again.
7. Replace the cover.
NOTE!
Check the large chain is tighened correctly in the whole rotation area after
adjusting the chains.
6.0 Long live Reel Rotator