11
Operation
Switching On Your Wine Cooler
1. The internal temperature of the wine cooler is
controlled by a thermostat. There are four settings
COLD, NORMAL, WARM and OFF.
2. Before connecting the wine cooler to the mains
socket, make sure that the thermostat control dial,
located at the front of the wine cooler is set to
COLD. Connect the mains cable to the mains socket
and switch on the mains.
3. After the wine cooler has been on for 20 minutes
adjust the thermostat control dial to NORMAL.
This is the recommended setting when operating
at normal room temperature (between 16°C and
32°C).
4. The wine cooler may not operate at the correct
temperature if it is in a particularly hot or a
particularly cold room, or if you open the door
often.
5. If you are concerned that the wine cooler is not
being kept cold enough and wish to check the
temperature you will need a special fridge/freezer
thermometer. You may also need a hygrometer to
check the humidity of your wine cooler. These are
available from most supermarkets and hardware
shops.
Place the thermometer and hygrometer on the
middle shelf of the wine cooler, where it can be
read easily. Leave overnight, the temperature in the
wine cooler should be between 5°C and 20°C and
the humidity in the wine cooler should be between
50%-80% RH depending on the type of wine.
NORMAL
COLD
WARM
OFF
In the OFF position the wine cooler will
not operate, but the power supply remains
connected.
LWC59B12_IB_Running Change_120822_Edits_Pauline.indd 11
22/08/2012 11:59 AM
