11
Hints and Tips
Problem
Possible Solutions
My burner does not
light
• Check the hob is plugged in and the electricity is switched on.
• Check the gas supply valve is turned on and the gas supply to the house
is working. You should hear the gas when you turn a burner on.
• The ignitors may be dirty. Clean gently with a small nylon brush such as a toothbrush.
• The burner parts may not be located properly. Check the assembly and make sure the
burner cap is sitting flat.
My burner flames
are yellow or hard
to start
• The burner parts may not be located properly. Check the assembly and make sure the
burner cap is sitting flat.
• If you use bottled gas this may indicate you are getting near the end of the bottle.
• Check the burner parts are clean and dry.
• The gas pressure may not be at the correct level. Check with your approved service
agent.
• Your hob may not be set up for the gas you are using. Check this with your approved
service agent or installer.
One of my burners
has an uneven
flame
• Check the burner parts are clean and dry. Check the assembly and make sure the
burner cap is sitting flat.
My burner goes out
when I let go of the
control
• The hob has a safety feature called ‘Flame Supervision Device (FSD)’. Hold down the
control for approximately 5 – 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the flame. See the ‘Flame Failure Safety Feature’ section.
The flame goes out
at low settings
• The gas supply pressure may be low. Check this with your approved service agent.
• The low setting may have been adjusted incorrectly. Check this with your approved
service agent.
My burners do not
turn down much
(when running on
bottled gas or LPG)
• Your burners may not have been adjusted correctly. Check this with your approved
service agent.
The flame tips are
very yellow
• Call your approved service agent.
There are
objectionable
odours
• Call your approved service agent.
• Ensure the hob and burners are clean and dry.
The flame appears
to lift off the burner
• Call your approved service agent.
There is an
electricity failure
• If there is an electricity failure, you can still use your hob. Light the burners by holding
a candle lighter close to the side of the burner and turning the control to the High
position. Wait until the flame is burning evenly before adjusting. The control must still
be held down for 5 – 10 seconds after the burner has lit. Releasing the control too
soon will extinguish the flame.
LGHOBX12_IB_120601_Annie(Check).indd 11
12年6月1日 下午5:14
