Logik L60CHDB10, Инструкция по эксплуатации и монтажу

Страница: 17 / 24

17
4. Using two of the 5.5 x 60 mm YSB screws, screw into the wall fixings leaving a 5mm gap between the
bottom of the screw head and the wall. Hang the appliance on the two screws and ensure it is level.
5. Locate the two safety holes on the inside of the appliance
and mark these on the wall surface. Temporarily place the
internal and external chimney parts on the top of the hood
and mark the position of the chimney connection plate
holes on the wall surface.
6. Remove the chimney sections and hood from the wall.
7. Ensuring there is no pipe work or wires buried in the wall,
use a 10mm drill bit and drill the two safety holes to a
sufficient depth to insert the two remaining wall fixings
flush into the wall. Using a 6 mm drill bit, drill the two holes
for the chimney connection plate and insert the two 6 mm
wall fixings flush to the wall.
8. Using the two 3.9 x 22 mm YSB screws, secure the chimney
connection plate to the wall. Tighten the screws fully.
11. Insert the internal chimney section into the external section and using the two remaining 3.5 x 9.5mm
screws secure to the chimney mounting plate.
12. Ensure all protective coverings have been removed from the metal surfaces prior to use.
13. Follow the operation instructions in this manual for safe operation of this appliance.
9. Refit the hood to the wall and insert the two safety screws into the safety holes. Ensure the unit is level and
fully tighten the screws. Fully tighten the two keyhole screws.
10. Fit the external chimney section to the hood using two of the 3.5 x
9.5 mm screws.
For L60CHDX10 & L60CHDB10
safety hole
For L90CHDX10
safety hole
L60CHDB10_L60_90CHDX10_IB_110524_glo.indd 17 24/05/2011 5:42 PM