Logik L44DAB10, Инструкция по эксплуатации

Страница: 7 / 20

7
Switching on Your Unit for the First Time
1. Switch the ON/OFF switch at the back of the unit to “ON” position to turn the unit on. For
initial use, the unit will automatically enter the DAB mode and start the auto tune quick
scan for DAB stations.
2. During scanning, the display will show a slide bar that indicates the progress of the scan,
and the amount of radio stations that have been found so far. Once the scan has finished,
the unit will select the first alphanumeric station.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could
cause personal injury or damage to property.
• Install the batteries correctly by following the polarity (+ and –) indications in the battery
compartment.
• Use only the types of the batteries which are indicated in this manual.
• Do not install new batteries with used ones and do not mix different types of batteries.
• Do not dispose of the used batteries as domestic waste. Dispose of them in accordance with
local regulations.
• If you are not going to use the unit for a long time, remove the batteries to avoid damage
from battery leakage and corrosion.
• Do not take more than 1 minutes to replace the batteries, otherwise the clock, any lists
of receivable broadcasts for DAB scan, preset favourite services and all settings will be
initialized. Should that happen, set the functions again.
• If the batteries are replaced while the power is on, the unit may revert to the factory setting.
• Due to the short battery life span of some alkaline batteries. It is recommended to use
rechargeable batteries. You will need to purchase a charger to charge the rechargeable
batteries. This saves cost and is more environmentally friendly.
The name of the found group of DAB radio stations will
be displayed in the bottom half of the display.
L44DAB10_IB_final100429.indd 7 29/04/2011 12:15 PM