DMD660 - OPERATING MANUAL // PAGE 21
9 ASSEMBLY - END POINTS
9.1 STEP 1 - ATTACHING THE MOTOR END
The Motor End is connected to the Height-Adjustable Column with a specially-made Top Plate.
NOTICE
Attaching the Motor End incorrectly could damage the DMD660. The following
guidelines apply during this stage of the assembly process. Failure to comply will void
warranty claims.
• Do not lift the DMD660 by its cable
• Ensure the Top Plate is designed according to LOGICDATA specifications
• Do not mount the Top Plate without the Rubber Washers
• Only use the Screws provided by LOGICDATA to mount the Top Plate
• Use a Torque Screwdriver to ensure the Screws are tightened to the recommended
torque of 2.5 - 3 Nm
9.1.1 REQUIRED COMPONENTS
1
Mounting Screws and Rubber Washers
(Ordered separately: Contact LOGICDATA)
2
Top Plate (developed by Reseller: contact LOGICDATA
for specifications)
3
DMD660
Tool
Torque Screwdriver
INFO
LOGICDATA provides specifications for the Top Plate only on request. These include
dimensions and tolerances, as well as notes on material selection and assembly.
Failure to adhere to LOGICDATA specifications will void warranty claims.
9.1.2 PROCESS
To attach the Motor End of the DMD660:
1. Insert the Mounting Screws through the Top Plate into the holes at the top of the DMD660
2. Use the Torque Screwdriver to tighten the Screws to 2.5 - 3 Nm.
1
2
3
