ZOOM ColdFire SDK
12
QuickStart Guide
3 QuickStart
3.1 Inserting the Fire Engine into the Baseboard
Insert the Fire Engine connector into the SODIMM connector on the baseboard.
1.
Firmly press the Fire Engine into the SODIMM connector until it is fully seated.
2.
Press the Fire Engine down onto the baseboard expansion connectors.
3.
Verify that the expansion connectors on the Fire Engine and baseboard have mated
correctly and the SODIMM connector locks have locked with the Fire Engine down.
To remove the Fire Engine, first pull up on expansion connectors to release them,
then release the connector locks on both sides of the SODIMM connector and lift
up on the non-SODIMM edge of the Fire Engine.
Note:
Please refer to Logic's White Paper 318
Card Engine Insertion and Extraction
Procedure
for detailed directions on how to avoid damaging the Fire Engine when inserting
and removing it from the baseboard.
Figure 3.1 – Inserting the Fire Engine into the Baseboard
Expansion Connectors
SODIMM Connector Locks
Final Position
SODIMM Connector