NMP – User Guide, Version 3.00
Introduction
This document describes the details of the Navigation and Messaging Platform(NMP), a
platform providing the combined functionality of a navigation system with fleet management
and a Mobile Data Terminal, MDT.
This document will describe the installation and use of the NMP, and for information about
the usage of the PNM-100 and PNM-200 devices please refer to the Technical Manual for
those products.
The package contains either an SD card with the application, or a Windows CE device with
the application already installed on an SD card.
The NMP is controlled and managed from the RTCU application and for more detailed
information on the programming, please consult the RTCU IDE online help.
The RTCU application runs on an NMP enabled RTCU with firmware 2.64 or higher and the
NMP application runs on a Windows CE 5.0 device with .Net Compact Framework 2.0 or
higher.
To change an RTCU application from using a Garmin navigation devices and/or an MDT to
use an NMP, very few changes are needed; The navigation interface must be opened before
the MDT interface, and the NMP must be fed GPS data by calling
gpsFix()
1
repeatedly for
the navigation part to work.
1 See Online Help, Navigation section.
Page 3 of 28
Logic IO Aps
Ph: (+45) 7625 0210
Holmboes Allé 14
Fax: (+45) 7625 0211
8700 Horsens
Email:
Denmark
www.logicio.com
MDT
Navigation
Powered by Sygic
Windows CE 5.0
RTCU device
or RTCU IDE
simulator
Connection cable
GPS
GPRS
RTCU Gateway
Custom Fleet Navigation Application
with RTCU support
WWW