8
Station Address:
Select station address value (0 to 15). This station address is optional.
It’s for easier quick identification of individual stations on top of the IP
address.
Status line:
Display status line message at bottom of screen on boot (ON or OFF).
Ethernet icon:
Display of Ethernet status icon at bottom right of screen on boot (ON or
OFF).
Keyboard icon:
Display of keyboard status icon at bottom right corner of screen on boot
(ON or OFF).
Font code page:
Select default font code page (tcp437, tcp850, tcp852 or tcp857).
.
ETHERNET menu
IP ADDRESS:
Setup IP address of the unit with numeric keys (must match with host
PC IP group).
SUBNET MASK:
Setup Subnet Mask with numeric keys (default 255.255.255.0).
PORT NUMBER:
Setup TCP port number with numeric keys (must match with application
software).
SERIAL menu
Baud rate:
Select serial port baud rate (2400, 4800, 9600 or 19200)
Parity Check:
Select parity check option (none, odd, or even)
Bit number:
Select bit number option (7 bits or 8 bits)
Flow Control:
Select flow control option (none or hardware)
Device Driver:
Select or disable integrated device driver for the COM port
DIAGNOSTIC menu
1. VGA color test:
Display 256 color palette for checking. If the colors displayed are
not correct, adjust or replace the monitor.
2. Keyboard input test:
Display codes of keys entered on the attached keyboard to verify
keyboard function. If the corresponding key code does not
appear, check the keyboard connection at the LS6100. If the
correct code still does not appear, replace the keyboard.
3. Beeper test:
Test beep sound. Adjust beeper pitch on MAIN menu if
necessary.
4. COM1 port and
driver test:
If device driver is enabled, this will setup and test the device with
the driver. If device driver is disabled, connect a wrap plug to the
port for testing serial port function. If the test fails, the LS6100 is
not able to work with the attached RS-232 device. If the test is
passed but the port does not work with the peripheral device,
check the serial cable for proper connection and pin-out.
5. COM2 port and
driver test:
Same as above.
