40
29.
Undefined user-defined character <1B> <3F> <n>
Undefined character code
n
previously defined by user. Built-in font is used
subsequently.
<20> <=
n
<= <7F>
30.
Select/cancel user-defined character set <1B> <25> <n>
Set cursor ON or OFF.
n
= <00> cancel user-defined character set. Built-in character set is used.
n
= <01> enable user-defined character set.
31.
Store user-defined character in EEPROM <1B> <73> <01>
This command is valid only if the display is in enable mode, as set by <Esc> =
command.
32.
Restore user-defined character from EEPROM <1B> <64> <01>
Restore user-defined character pattern that was previously stored by command:
<1B> <73> <01>
33.
Save current display data in EEPROM <1B> <53> <n>
Store the current display image for future demo display.
n
= <31> save image in layer 1.
n
= <32> save image in layer 2.
. . .
n
= <35> save image in layer 5.
34.
Display saved data from EEPROM <1B> <44> <n> <m>
The data saved by
“<1B> <53>
n
” can be displayed by this command.
The layer to be displayed is selected by the bit position within the byte of
n
.
<01> <=
n
<= <1F>
<31> <=
m
<= <33>
35.
Adjust brightness <1B> <2A> <n>
Adjust display brightness.
n = <01>, 20%
n = <02>, 40%
n = <03>, 60%
n = <04>, 100%. Default mode.
36.
Set output device mode <1B> <3D> <n>
Set output device mode.
n
= <01> display disable next device enable.
n
= <02> display enable next device disable.
n
= <03> display enable next device enable.
<Data>:
No more than 20 characters.
