Logia LOWSC710B, Руководство пользователя

Страница: 9 / 32

9
4. Insert the bottom side of the pole into the mounting base
(included). Make sure the square holes are aligned with each
other.
5. Insert the screw through the holes of the pole and base then
tighten the hexagonal nut onto the other end of the screw.
Use a screwdriver or wrench if needed.
6. Add rubber pads onto mounting clamp before fastening the
mounting clamp on the mounting base.
7. Place the mounting base onto a post and place the mounting
clamp on the other side of the post.
8. Align the holes of the mounting base and mounting clamp,
then tighten the two together using four (4) included
screws, washers, and hexagonal nuts.
NOTES: Place the mounting base and clamp on a steel
pole or post with a 1″ – 1.3″ (25 – 33 mm) diameter
and is a minimum of 4.9′ (1.5 m) off the ground.
When setting up the outdoor sensor, make sure the
wind pane side is facing north.
When placing the outdoor sensor, make sure it is
within 492′ (150 m) of the display console.