Trouble Shooting
Problem
Solution
Moulding splinters.
Reverse sanding direction.
Apply less pressure to surface being sanded.
Not producing 45 degree angle.
Refer to instructions for making adjustments using micro-adjustment blocks. Only small incre-
mental adjustments are required.
Remove any debris between moulding and fence.
Remove any debris between fence and micro-adjustment stop(s).
Make sure center bolt on sanding wheel is tight.
Rough surface after sanding.
Clean sanding disk with supplied cleaning bar.
Replace sand paper disk.
Apply less pressure to surface being sanded.
Gaps appear in moulding joints.
Sand surface until a fine line of dust appears across the top of the moulding.
Warranty
Logan Graphic Products, Inc. (“Logan”) warrants the Precision Sander Elite - Model F200-2, to be free from defects in parts and workmanship for a period of one
year from the date of original purchase. Logan warrants that it will either repair or replace, at its’ sole discretion, any necessary replacement parts found to be
defective. Should the product need to be returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing. Costs of
returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be liable for any damages or losses, incidental or consequen-
tial, direct or indirect, arising from the use of this product. This warranty extends only to the original purchaser and is not assignable or transferable. This warranty is
in lieu of all other warranties, expressed or implied.
Instruction Manual
Model F200-2
Precision SANDER ELITE
Cleaning
1.
Hold the cleaning bar at 45 degrees and move down the length of
the wheel while rotating (Fig. 6).
2.
Use light pressure.
NOTE: Surface of sandpaper may not look clean
but it is. The dust sticks to the backing material not the raised
abrasive grit.
Adjustment 45°
1.
Remove sand paper
2.
Place the 45˚ square flat against the wheel and up against bar
(Fig. 7). Look for gaps against the bar.
3.
Adjust the bar using adjustment wrench until gap disappears.
Changing Disk Paper
1.
Remove disk using disk wrench.
2.
Remove worn sandpaper and clean surface of disk of any glue or
debris using a razor blade or mineral spirits.
3.
Peel off adhesive backing and apply sandpaper
to disk carefully. Press thoroughly to remove any bubbles.
Fig. 6
Fig. 7
45° Triangle
L689N2 1/10
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
