LOFTNESS GrainLogix GBU 12, Руководство пользователя и каталог запасных частей

Страница: 25 / 108

19 Grain Bag Unloader OM
Getting Started
Extracting grain from the bag requires three people . One
person is needed in or on the tractor at all times to start
and stop the PTO shaft and to guide the tractor on center .
Another person is needed at the unloader to monitor grain
intake and to pause the unloader when the grain transport
vehicle is full . The third person is needed to move the grain
transport vehicle and monitor when the vehicle is full .
WARNING: Do not wear loose hanging
clothes, neckties or jewelry. Long hair is to
be placed under a cap or hat. These
precautions will help prevent you from
becoming caught in any moving parts on the
machine.
WARNING: Always have an operator in the
tractor while the machine is in operation.
WARNING: The machine requires an
operator at all times. Never leave the
machine running and unattended.
Start extracting grain at the end of the grain bag where
the storage process was finished . The extra length of
bag that is left at the end of storage process will make it
easier to wrap the bag around the unloader’s roller and
start the extraction process .
NOTE: Extraction from the opposite end of the grain
bag is possible, but it will require removing some
grain manually before you are able to extract
grain with the unloader.
Remove the bag end from underneath the grain bag and
unroll to expose the planks .
Remove the planks sealing the bag .
NOTE: The bag may be cut with a utility knife to remove
the planks. Cut the bag at the planks, leaving as
much of the bag end as possible.
1st Cut
Horizontal Cut
2nd Cut
Vertical Cut
First, make a horizontal cut, approximately 12 in . (305
mm) long, towards the top where the bag is more full .
The cut should be slightly off center where it would line
up with the unloader’s cutting knife (1) .
CAUTION: Do not enter inside the bag.
Potential entrapment and suffocation are
possible.
NOTE: It is important to make the horizontal cut first,
before any vertical cuts are made, or the bag
could keep opening completely from being
stretched and full of grain. Do not cut into the
tension portion of the bag.
Second, make a vertical cut just below the horizontal cut
all the way to the end of the bag . The cut should line up
with the unloader’s cutting knife (1) .
NOTE: If there is not enough grain bag to attach it to
the unloader’s roller, some grain will need to be
extracted manually. Remove enough grain until
the bag can be installed onto the roller.
Operating Instructions