9
READ ALL WARNINGS BEFORE INSTALLING GLASS!
• The filter glass is made of compound glass and
weighs approximately 20 pounds. It is breakable
if treated improperly.
• Always use the supplied nonslip gloves to
prevent damage when removing the glass from
the carton and during assembly.
• Make sure the glass is positioned securely so it
cannot slip or tip over during preparation for
assembly.
• Do not set the glass down on a hard or slick
surface.
• Keep children away from all packing material
and stickers.
• Once the glass is in place, treat it with care. Do
not tap the glass with a blunt or sharp object
(e.g. hammer, or sharp tool).
• Use only the supplied mounting screws, and
HAND-TIGHTEN them to prevent damage—DO
NOT OVERTIGHTEN!
• If the glass breaks, use extreme caution: Do not
touch the glass unless you are wearing protec-
tive gloves and special protective clothing.
Thoroughly remove and dispose of all glass
fragments and keep glass fragments away from
children.
• Remove the glass if: 1) it becomes scratched or
cracked, or 2) you plan to ship the television.
Use the original packaging if at all possible for
transportation of the television.
• To uninstall the filter glass, please follow the
instructions in reverse.
ART 636 FILTER GLASS INSTALLATION
TV
Glass
A
B
Gently fasten the filter glass to the television cabinet using the four supplied thumb-tight mounting
screws and spacers. DO NOT OVERTIGHTEN!
How to Install Filter Glass
Installing the filter glass requires nonslip gloves
(supplied) and two people: one to hold the glass
and one to insert and hand-tighten the four
mounting screws.
1 Carefully remove the filter glass from the carton
and place it lengthwise on a soft, nonslip
surface.
2 Put on the supplied nonslip gloves before
removing the protective cover. If necessary,
clean the front and back of the glass with a soft
cloth before installing.
3 Insert each thumb-tight screw (A) into its white
plastic spacer (B) as shown in the diagram at
left.
4 Position the glass against the television so the
four screw holes are in alignment. The glass is
curved and follows the contour of the cabinet.
The front of the glass is indicated by the LOEWE
logo, model number, and attached sticker(s).
5 Insert and tighten all four mounting screws just
enough to hold the glass in place, then gently
snug each screw until the glass fits securely to
the cabinet.
WARNING: DO NOT OVERTIGHTEN, AS THIS
COULD BREAK OR PERMANENTLY DAMAGE
THE GLASS!!!
6 Remove the warning sticker(s) from the front of
the glass.
7 Installation is complete!
Support Tabs