Loewe Individual 26 Selection, Руководство по эксплуатации

Страница: 90 / 112

- 90
english
Problem Possible cause Remedy
All menus are displayed in the wrong
language .
The menu language was set incorrectly. Set the menu language:
Press the MEDIA button in TV mode . In the MediaPortal ,
highlight the last menu item ( Index ) in the upper half and
call up with OK . Mark the first key word and call it with
OK . Then select the language and confirm it with OK .
In the TV menu , Connections cannot be
called (displayed in grey ).
A timer recording is in progress. Wait until the timer recording ends or delete the
timer recording (page 85).
The control functions of the Loewe
Recorder and the
Timer are not working
or are not working properly
a) The Digital Link function is not activated or
not possible in the recorder.
b) EURO-AV cable is not connected.
a) Activate Digital Link in the recorder (see operat-
ing instructions of the recorder).
b) Connect EURO-AV cable (page 77).
General problems when connecting
external devices via an AV input .
a) The AV standard is set incorrectly.
b) The signal type is set incorrectly.
a) Set the correct standard (page 74).
b) Set the correct signal type (page 74).
If AV standard or AV signal is set to “Automatic”
then this can cause errors to be detected with
signals that do not comply with standards. In this
case standard and signal must be set according to
the information in the operating manual of the
external device.
The connection of a decoder does not
function or does not function properly.
a) The signal is not decoded because the correct
decoder stations are not selected in the menu.
b) The sound is missing in decoder mode becau-
se the wrong decoder sound is assigned in the
menu.
a) Select the right decoder stations in the menu ( TV
menu
<
Connections
<
Miscellaneous
<
Decoder
stations < Select decoder station(s) (see page 75).
b) Select the right sound code (always, never, automa-
tic) in the menu ( TV menu
<
Connections
<
Miscellaneous
<
Decoder stations
<
Sound encodig ),
see also decoder instructions.
Digital Link Plus does not work. a) EURO-AV cable is not fully wired (pin 10 not
wired).
b) Some recorders can only adopt stations
during the initial installation of the TV set.
a) Replace the EURO-AV cable.
b) Restore the recorder to the as-delivered state
(see recorder’s operating manual).
With Teletext various characters are
displayed incorrectly.
The wrong character set has been set in the
Teletext menu.
Set the right character set: Select Teletext menu
<
Settings < Character set < Standard or the
appropriate character set.
Errors occurred when running a CA
module. Switch the TV set off. Remove the CA-module from
the TV set. Wait a few seconds. Reinsert the CA-
module. Switch the TV set on again.
Troubleshooting