Loepfe Savio FRS 3000, Инструкция по установке

Страница: 22 / 30

22
3N1
SYSTEM SETUP
7. Check the following values in the menu after approx.
1 hour full operation:
Machine Data / Hitlist / Quality
– Reference Mean
– Actual Mean
– Dust Value
– CV%
Machine Data / Hitlist / Foreign Fiber
– Actual Value
– Std. Deviation
Machine Data / Hitlist / Polyprop
– Actual Value
– Std. Deviation
The statistic, which can be called off with the magnifier sym-
bol, shows possible deviations from the mean value. If they are
too large, clean the SH and restart with a new mean value. If it is
still to large, exchange the SH (interchange control for testing).
Reference Value for Q at empty optic: actual Mean 0
Reference Value for Q at empty optic with running yarn:
almost 0
Picture 1
Trouble Shooting
If you have any trouble with one rotor position e.g. too many
cuts, use the rotor clearer data for the following action:
Make new mean: New adjusting of the current yarn. It’s pos-
sible to start during production of the rotor. We recommend
to Stop and clean the sensor before you start a new mean.
Force Stop: Check for communication. The rotor position
will start again with production as soon as the piecing robot
reaches the position.
Force Lock: for service purpose. If you need one or more po-
sition on a stop (e.g. for maintenance purpose) you should
use the lock function. The lock needs to be unlocked on the
overview page once you want to start production on the
blocked rotors again.
Rotor Unlock: at overview screen
A locked rotor must be inspected by qualified personnel.
At least you need to clear the sensor before you start again
with the yarn production. A fault or a malfunction are to be
mended.
After elimination, unlock the rotor.
Use statistic for further analysis. Figure cut bad running sen-
sors for Q, F and P are shown in Picture 1.